anchor door knocker
It can be difficult to find a new door knocker with the same BC dimension. Especially if the original one has been there for many years. There is no standard for the BC dimension. The BC for the most part is determined by the design of the knocker. The mounting lugs used to attach the hardware are usually placed at a thicker portion of the casting. This is to give them more strength. Sometimes you have to settle for a replacement that is close. If the two BCs are within 1/4 or 3/8 inch of each other you can usually enlarge the holes in the door a bit to make the fit. If you are lucky the existing mounting hardware will cover the enlarged holes.
If not a larger washer will usually do the trick. If the replacement door knocker BC dimension is not even close one of the existing holes can be used but the second matching hole must be drilled through the door for the mounting. This leaves the other previous hole to cover up. If puttying and repainting is not an option I have used a third mounting hardware bolt and epoxy it into the unused hole. This gives the appearance on the inside that three bolts are used on this door knocker. This looks natural and is easy to do. The outside portion of the hole is covered by the door knocker but should still be filled with putty to prevent future problems with moisture. With a little luck you will find a matching door knocker.
Most Popular This Week
This material has a long life and is available in different creative designs. The rear mounting is done by drilling the door thus the knocker is firmly fixed on it. The styles you choose is a personal affair as it brings out your own attributes. You should however choose a knocker that will look natural on your door. You can renew the look of your front door by installing a new knocker or replacing the old one along with old knobs deadbolts kick plates doorbell and your mail slot. Door knockers have been important symbols throughout history and have been mentioned in a lot of metaphors.
If lacquered or plated the engraving process can cut through and expose the base metal below. An engraved door knocker should be engraved before the plating or lacquering process. A door knocker makes a wonderful gift or is a great addition to your own home. Careful shopping and little research will go a long way in getting the best value. Are you about to replace an older doorknocker with a new one? Perhaps you are looking for a different style or finish. In any case shopping for a door knocker can be a frustrating task. There is not only the choice of style and finish you must match or cover the impressions and holes left from the previous one.